NR 661.0009 NoteNote: The additional language used in this section clarifies that LDR treatment standards apply to universal waste. This language is not more stringent than 40 CFR 261.9. NR 661.0009 HistoryHistory: CR 19-082: cr. Register August 2020 No. 776, eff. 9-1-20; correction in (intro.) made under s. 35.17, Stats., Register August 2020 No. 776; correction in (intro.) made under s. 35.17, Stats., Register April 2021 No. 784. subch. B of ch. NR 661Subchapter B —Criteria for Identifying the Characteristics of Hazardous Waste and for Listing Hazardous Waste NR 661.0010NR 661.0010 Criteria for identifying the characteristics of hazardous waste. NR 661.0010(1)(1) The department shall identify and define a characteristic of hazardous waste under subch. C only upon determining that all of the following are met: NR 661.0010(1)(a)(a) A solid waste that exhibits the characteristic may do any of the following: NR 661.0010(1)(a)1.1. Cause, or significantly contribute to, an increase in mortality or an increase in serious irreversible, or incapacitating reversible, illness. NR 661.0010(1)(a)2.2. Pose a substantial present or potential hazard to human health or the environment when it is improperly treated, stored, transported, disposed of or otherwise managed. NR 661.0010(1)(b)1.1. Measured by an available standardized test method which is reasonably within the capability of generators of solid waste or private sector laboratories that are available to serve generators of solid waste. NR 661.0010(1)(b)2.2. Reasonably detected by generators of solid waste through their knowledge of their waste. NR 661.0010 HistoryHistory: CR 19-082: cr. Register August 2020 No. 776, eff. 9-1-20. NR 661.0011NR 661.0011 Criteria for listing hazardous waste. NR 661.0011(1)(1) The department shall list a solid waste as a hazardous waste only upon determining that the solid waste meets one of the following criteria: NR 661.0011(1)(a)(a) It exhibits any of the characteristics of hazardous waste identified in subch. C. NR 661.0011(1)(b)(b) It has been found to be fatal to humans in low doses or, in the absence of data on human toxicity, it has been shown in studies to have an oral LD 50 toxicity measured in rats of less than 50 milligrams per kilogram, an inhalation LC 50 toxicity measured in rats of less than 2 milligrams per liter, or a dermal LD 50 toxicity in rabbits of less than 200 milligrams per kilogram or is otherwise capable of causing or significantly contributing to an increase in serious irreversible, or incapacitating reversible, illness. Waste listed in accordance with these criteria will be designated acute hazardous waste. NR 661.0011(1)(c)(c) It contains any of the toxic constituents listed in ch. NR 661 Appendix VIII and, after considering the following factors, the department concludes that the waste is capable of posing a substantial present or potential hazard to human health or the environment when improperly treated, stored, transported or disposed of, or otherwise managed: NR 661.0011(1)(c)3.3. The potential of the constituent or any toxic degradation product of the constituent to migrate from the waste into the environment under the types of improper management considered in subd. 7. NR 661.0011(1)(c)4.4. The persistence of the constituent or any toxic degradation product of the constituent. NR 661.0011(1)(c)5.5. The potential for the constituent or any toxic degradation product of the constituent to degrade into non-harmful constituents and the rate of degradation. NR 661.0011(1)(c)6.6. The degree to which the constituent or any degradation product of the constituent bioaccumulates in ecosystems. NR 661.0011(1)(c)7.7. The plausible types of improper management to which the waste could be subjected. NR 661.0011(1)(c)8.8. The quantities of the waste generated at individual generation sites or on a regional or national basis. NR 661.0011(1)(c)9.9. The nature and severity of the human health and environmental damage that has occurred as a result of the improper management of wastes containing the constituent. NR 661.0011(1)(c)10.10. Action taken by other governmental agencies or regulatory programs based on the health or environmental hazard posed by the waste or waste constituent. NR 661.0011(1)(c)11.11. Such other factors as may be appropriate. Substances will be listed under ch. NR 661 Appendix VIII only if they have been shown in scientific studies to have toxic, carcinogenic, mutagenic or teratogenic effects on humans or other life forms. Wastes listed in accordance with these criteria will be designated toxic wastes. NR 661.0011(2)(2) The department may list classes or types of solid waste as hazardous waste if the department has reason to believe that individual wastes, within the class or type of waste, typically or frequently are hazardous under the definition of hazardous waste found in s. 291.01 (7), Stats. NR 661.0011(3)(3) The department will use the criteria for listing specified in this section to establish the exclusion limits referred to in s. NR 662.013 (3). NR 661.0011 HistoryHistory: CR 19-082: cr. Register August 2020 No. 776, eff. 9-1-20; correction in (1) (c) (intro.), 11. made under s. 35.17, Stats., Register August 2020 No. 776. NR 661.0020(1)(1) A solid waste, as defined in s. NR 661.0002, that is not excluded from regulation as a hazardous waste under s. NR 661.0004 (2), is a hazardous waste if it exhibits any of the characteristics identified in this subchapter. NR 661.0020 NoteNote: Section NR 662.011 sets forth the generator’s responsibility to determine whether its waste exhibits one or more of the characteristics identified in this subchapter. NR 661.0020(2)(2) A hazardous waste that is identified by a characteristic in this subchapter is assigned every EPA hazardous waste number that is applicable as set forth in this subchapter. This number shall be used in complying with the notification requirements under s. NR 660.07 and all applicable recordkeeping and reporting requirements under chs. NR 662 to 665, 668, and 670. NR 661.0020(3)(3) For the purposes of this subchapter, the department will consider a sample obtained using any of the applicable sampling methods specified in ch. NR 661 Appendix I to be a representative sample within the meaning specified in ch. NR 660.10 (101). NR 661.0020 NoteNote: Since ch. NR 661 Appendix I sampling methods are not being adopted by the department, a person who desires to employ an alternative sampling method is not required to demonstrate the equivalency of the method under the procedures set forth in ss. NR 660.20 and 660.21. NR 661.0020 HistoryHistory: CR 19-082: cr. Register August 2020 No. 776, eff. 9-1-20; correction in (3) made under s. 35.17, Stats., Register August 2020 No. 776. NR 661.0021(1)(1) A solid waste exhibits the characteristic of ignitability if a representative sample of the waste has any of the following properties: NR 661.0021(1)(a)(a) It is a liquid, other than an aqueous solution containing less than 24 percent alcohol by volume, and has flash point less than 60°C or 140°F, as determined by a Pensky-Martens Closed Cup Tester, using the test method specified in ASTM Standard D 93-79 or D 93-80, incorporated by reference in s. NR 660.11, or a Setaflash Closed Cup Tester, using the test method specified in ASTM Standard D 3278-78, incorporated by reference in s. NR 660.11. NR 661.0021(1)(b)(b) It is not a liquid and is capable, under standard temperature and pressure, of causing fire through friction, absorption of moisture or spontaneous chemical changes and, when ignited, burns so vigorously and persistently that it creates a hazard. NR 661.0021(2)(2) A solid waste that exhibits the characteristic of ignitability has the EPA hazardous waste number of D001. NR 661.0021 HistoryHistory: CR 19-082: cr. Register August 2020 No. 776, eff. 9-1-20; correction in (1) (a) made under s. 35.17, Stats., Register August 2020 No. 776. NR 661.0022(1)(1) A solid waste exhibits the characteristic of corrosivity if a representative sample of the waste has either of the following properties: NR 661.0022(1)(a)(a) It is aqueous and has a pH less than or equal to 2 or greater than or equal to 12.5, as determined by a pH meter using Method 9040C in “Test Methods for Evaluating Solid Waste, Physical/Chemical Methods,” EPA Publication SW-846, as incorporated by reference in s. NR 660.11. NR 661.0022(1)(b)(b) It is a liquid and corrodes SAE 1020 steel at a rate greater than 6.35 mm per year at a test temperature of 55°C as determined by Method 1110A in “Test Methods for Evaluating Solid Waste, Physical/Chemical Methods,” EPA Publication SW-846, and as incorporated by reference in s. NR 660.11. NR 661.0022(2)(2) A solid waste that exhibits the characteristic of corrosivity has the EPA hazardous waste number of D002. NR 661.0022 HistoryHistory: CR 19-082: cr. Register August 2020 No. 776, eff. 9-1-20. NR 661.0023(1)(1) A solid waste exhibits the characteristic of reactivity if a representative sample of the waste has any of the following properties: NR 661.0023(1)(a)(a) It is normally unstable and readily undergoes violent change without detonating. NR 661.0023(1)(d)(d) When mixed with water, it generates toxic gases, vapors or fumes in a quantity sufficient to present a danger to human health or the environment. NR 661.0023(1)(e)(e) It is a cyanide or sulfide bearing waste which, when exposed to pH conditions between 2 and 12.5, can generate toxic gases, vapors or fumes in a quantity sufficient to present a danger to human health or the environment. NR 661.0023(1)(f)(f) It is capable of detonation or explosive reaction if it is subjected to a strong initiating source or if heated under confinement. NR 661.0023(1)(g)(g) It is readily capable of detonation or explosive decomposition or reaction at standard temperature and pressure. NR 661.0023(2)(2) A solid waste that exhibits the characteristic of reactivity has the EPA hazardous waste number of D003. NR 661.0023 HistoryHistory: CR 19-082: cr. Register August 2020 No. 776, eff. 9-1-20; correction in (1) (h) made under s. 35.17, Stats., Register August 2020 No. 776. NR 661.0024(1)(1) A solid waste, except manufactured gas plant waste, exhibits the characteristic of toxicity if, using the Toxicity Characteristic leaching procedure, test Method 1311 in “Test Methods for Evaluating Solid Waste, Physical/Chemical Methods,” EPA Publication SW-846, as incorporated by reference in s. NR 660.11, the extract from a representative sample of the waste contains any of the contaminants listed in Table 2 at the concentration equal to or greater than the respective value given in that table. Where the waste contains less than 0.5 percent filterable solids, the waste itself, after filtering using the methodology outlined in Method 1311, is considered to be the extract for the purpose of this section. NR 661.0024(2)(2) A solid waste that exhibits the characteristic of toxicity has the EPA hazardous waste number specified in Table 1 which corresponds to the toxic contaminant causing it to be hazardous. Table 1
Maximum Concentration of Contaminants for the Toxicity Characteristic
1Hazardous waste number.
2Chemical abstracts service number.
3If o-, m-, and p-Cresol concentrations cannot be differentiated, the total cresol, D026, concentration is used. The regulatory level of total cresol is 200 mg/l.
4Quantitation limit is greater than the calculated regulatory level. The quantitation limit therefore becomes the regulatory level.
NR 661.0024 HistoryHistory: CR 19-082: cr. Register August 2020 No. 776, eff. 9-1-20. NR 661.0030(1)(1) A solid waste is a hazardous waste if it is listed in this subchapter, unless it has been excluded from this list under ss. NR 660.20 and 660.22. NR 661.0030(2)(2) The department will indicate the department’s basis for listing the classes or types of wastes listed in this subchapter by employing one or more of the following hazard codes: NR 661.0030 NoteNote: Chapter NR 661 Appendix VII identifies the constituent that caused the department to list the waste as a Toxicity Characteristic waste by the letter ‘E’ or toxic waste by the letter ‘T’ in ss. NR 661.0031 and 661.0032. NR 661.0030(3)(3) Each hazardous waste listed in this subchapter is assigned an EPA hazardous waste number that precedes the name of the waste. This number shall be used in complying with the notification requirements under s. NR 660.07 and certain recordkeeping and reporting requirements under chs. NR 662 to 670. NR 661.0030(4)(4) The following hazardous wastes listed in s. NR 661.0031 are subject to the exclusion limits for acutely hazardous wastes established in s. NR 662.013: EPA hazardous wastes numbers F020, F021, F022, F023, F026 and F027. NR 661.0030 HistoryHistory: CR 19-082: cr. Register August 2020 No. 776, eff. 9-1-20. NR 661.0031NR 661.0031 Hazardous wastes from non-specific sources. NR 661.0031(1)(1) Listed hazardous waste from non-specific sources. The following solid wastes are listed hazardous wastes from non-specific sources unless they are excluded under ss. NR 660.20 and 660.22 and listed in 40 CFR part 261, Appendix IX:
/exec_review/admin_code/nr/600/661
true
administrativecode
/exec_review/admin_code/nr/600/661/b/0011/1/c/10
Department of Natural Resources (NR)
Chs. NR 600-699; Environmental Protection – Hazardous Waste Management
administrativecode/NR 661.0011(1)(c)10.
administrativecode/NR 661.0011(1)(c)10.
section
true
