NR 283.03 HistoryHistory: Cr. Register, October, 1987, No. 382, eff. 11-1-87. NR 283.10NR 283.10 Applicability; description of the contact cooling and heating water subcategory. This subchapter applies to the discharge of pollutants from processes in the contact cooling and heating water subcategory to waters of the state and the introduction of pollutants into POTWs. The contact cooling and heating water subcategory is limited to processes where process water contacts the raw material or plastic product for the purpose of heat transfer during plastics molding and forming. NR 283.10 HistoryHistory: Cr. Register, October, 1987, No. 382, eff. 11-1-87. NR 283.11NR 283.11 Effluent limitations representing the degree of effluent reduction attainable by the application of the best practicable control technology currently available. NR 283.11(1)(1) Except as provided in 40 CFR 125.30 to 125.32, any existing point source subject to this subchapter shall achieve the effluent limitations representing the degree of effluent reduction attainable by the application of BPT, which are calculated by multiplying the average process water usage flow rate for the contact cooling and heating water processes at a point source times the following pollutant concentrations: NR 283.11(2)(2) The department shall obtain the average process water usage flow rate for the contact cooling and heating water processes from the permittee. NR 283.11 HistoryHistory: Cr. Register, October, 1987, No. 382, eff. 11-1-87. NR 283.12NR 283.12 Effluent limitations representing the degree of effluent reduction attainable by the application of the best available technology economically achievable. Based on EPA’s determination that BPT provides adequate control of toxic pollutants in contact cooling and heating process wastewater, BAT guidelines are equivalent to BPT guidelines. NR 283.12 NoteNote: BAT effluent limitations for bis(2-ethylhexyl) phthalate are reserved.
NR 283.12 HistoryHistory: Cr. Register, October, 1987, No. 382, eff. 11-1-87. NR 283.13NR 283.13 New source performance standards. NR 283.13(1)(1) Any new source subject to this subchapter shall achieve performance standards which are calculated by multiplying the average process water usage flow rate for the contact cooling and heating water processes at a new source times the pollutant concentrations indicated in Table 1. NR 283.13(2)(2) The department shall obtain the average process water usage flow rate for the new source contact cooling and heating water processes from the permittee. NR 283.13 NoteNote: NSPS for bis(2-ethylhexyl) phthalate are reserved.
NR 283.13 HistoryHistory: Cr. Register, October, 1987, No. 382, eff. 11-1-87. NR 283.14NR 283.14 Pretreatment standards for existing sources. Any existing source subject to this subchapter that introduces pollutants into a POTW shall comply with ch. NR 211. NR 283.14 NoteNote: PSES for bis(2-ethylhexyl) phthalate are reserved.
NR 283.14 HistoryHistory: Cr. Register, October, 1987, No. 382, eff. 11-1-87. NR 283.15NR 283.15 Pretreatment standards for new sources. Any new source subject to this subchapter that introduces pollutants into a POTW shall comply with ch. NR 211. NR 283.15 NoteNote: PSNS for bis(2-ethylhexyl) phthalate are reserved.
NR 283.15 HistoryHistory: Cr. Register, October, 1987, No. 382, eff. 11-1-87. NR 283.16NR 283.16 Effluent limitations representing the degree of effluent reduction attainable by the application of the best conventional pollutant control technology. NR 283.16(1)(1) Except as provided in 40 CFR 125.30 to 125.32, any existing point source subject to this subchapter shall achieve the effluent limitations representing the degree of effluent reduction attainable by the application of BCT which are calculated by multiplying the average process water usage flow rate for the contact cooling and heating water processes at a point source times the pollutant concentrations indicated in Table 1. NR 283.16(2)(2) The department shall obtain the average process water usage flow rate for the contact cooling and heating water processes from the permittee. NR 283.16 HistoryHistory: Cr. Register, October, 1987, No. 382, eff. 11-1-87. NR 283.20NR 283.20 Applicability; description of the cleaning water subcategory. This subchapter applies to the discharge of pollutants from processes in the cleaning water subcategory to waters of the state and the introduction of pollutants into POTWs. The cleaning water subcategory is limited to processes where process water contacts the surface of an intermediate or final plastic product, or the surfaces of shaping equipment used in plastics molding and forming, for the purpose of surface cleaning. NR 283.20 HistoryHistory: Cr. Register, October, 1987, No. 382, eff. 11-1-87. NR 283.21NR 283.21 Effluent limitations representing the degree of effluent reduction attainable by the application of the best practicable control technology currently available. NR 283.21(1)(1) Except as provided in 40 CFR 125.30 to 125.32, any existing point source subject to this subchapter shall achieve the effluent limitations representing the degree of effluent reduction attainable by the application of BPT, which is calculated by multiplying the average process water usage flow rate for the cleaning water processes at a point source times the following pollutant concentrations: NR 283.21(2)(2) The department shall obtain the average process water usage flow rate for the cleaning water processes from the permittee. NR 283.21 HistoryHistory: Cr. Register, October, 1987, No. 382, eff. 11-1-87. NR 283.22NR 283.22 Effluent limitations representing the degree of effluent reduction attainable by the application of the best available technology economically achievable. Based on EPA’s determination that BPT provides adequate control of toxic pollutants in cleaning process wastewater, BAT guidelines are equivalent to BPT guidelines. NR 283.22 HistoryHistory: Cr. Register, October, 1987, No. 382, eff. 11-1-87. NR 283.23NR 283.23 New source performance standards. NR 283.23(1)(1) Any new source subject to this subchapter shall achieve performance standards calculated by multiplying the average process water usage flow rate for cleaning processes at a new source times the pollutant concentrations indicated in Table 2. NR 283.23(2)(2) The department shall obtain the average process water usage flow rate for the new source cleaning water processes from the permittee. NR 283.23 HistoryHistory: Cr. Register, October, 1987, No. 382, eff. 11-1-87. NR 283.24NR 283.24 Pretreatment standards for existing sources. Any existing source subject to this subchapter that introduces pollutants into a POTW shall comply with ch. NR 211. NR 283.24 HistoryHistory: Cr. Register, October, 1987, No. 382, eff. 11-1-87. NR 283.25NR 283.25 Pretreatment standards for new sources. Any new source subject to this subchapter that introduces pollutants into a POTW shall comply with ch. NR 211. NR 283.25 HistoryHistory: Cr. Register, October, 1987, No. 382, eff. 11-1-87. NR 283.30NR 283.30 Applicability; description of the finishing water subcategory. This subchapter applies to the discharge of pollutants from processes in the finishing water subcategory to waters of the state and the introduction of pollutants into POTWs. The finishing water subcategory is limited to processes where process water contacts the plastic product for the purpose of removing waste plastic material or lubricating a plastic product during finishing. NR 283.30 HistoryHistory: Cr. Register, October, 1987, No. 382, eff. 11-1-87. NR 283.31NR 283.31 Effluent limitations representing the degree of effluent reduction attainable by the application of the best practicable control technology currently available. NR 283.31(1)(1) Except as provided in 40 CFR 125.30 to 125.32, any existing point source subject to this subchapter shall achieve the effluent limitations representing the degree of effluent reduction attainable by the application of BPT, which is calculated by multiplying the average process water usage flow rate for the finishing water processes at a point source times the following pollutant concentrations: NR 283.31(2)(2) The department shall obtain the average process water usage flow rate for the finishing water processes from the permittee. NR 283.31 HistoryHistory: Cr. Register, October, 1987, No. 382, eff. 11-1-87. NR 283.32NR 283.32 Effluent limitations representing the degree of effluent reduction attainable by the application of the best available technology economically achievable. Based on EPA’s determination that BPT provides adequate control of toxic pollutants in finishing process wastewater, BAT guidelines are equivalent to BPT guidelines. NR 283.32 NoteNote: BAT effluent limitations for bis(2-ethylhexyl) phthalate, di-n-butyl phthalate, and dimethyl phthalate are reserved.
NR 283.32 HistoryHistory: Cr. Register, October, 1987, No. 382, eff. 11-1-87. NR 283.33NR 283.33 New source performance standards. NR 283.33(1)(1) Any new source subject to this subchapter shall achieve performance standards which are calculated by multiplying the average process water usage flow rate for the finishing water processes at a new source times the pollutant concentrations indicated in Table 3. NR 283.33(2)(2) The department shall obtain the average process water usage flow rate for the new source finishing water processes from the permittee. NR 283.33 NoteNote: NSPS for bis(2-ethylhexyl) phthalate, di-n-butyl phthalate, and dimethyl phthalate are reserved.
NR 283.33 HistoryHistory: Cr. Register, October, 1987, No. 382, eff. 11-1-87. NR 283.34NR 283.34 Pretreatment standards for existing sources. Any existing source subject to this subchapter that introduces pollutants into a POTW shall comply with ch. NR 211. NR 283.34 NoteNote: PSES for bis(2-ethylhexyl) phthalate, di-n-butyl phthalate, and dimethyl phthalate are reserved.
NR 283.34 HistoryHistory: Cr. Register, October, 1987, No. 382, eff. 11-1-87. NR 283.35NR 283.35 Pretreatment standards for new sources. Any new source subject to this subchapter that introduces pollutants into a POTW shall comply with ch. NR 211. NR 283.35 NoteNote: PSNS for bis(2-ethylhexyl) phthalate, di-n-butyl phthalate, and dimethyl phthalate are reserved.
NR 283.35 HistoryHistory: Cr. Register, October, 1987, No. 382, eff. 11-1-87. NR 283.40NR 283.40 Cross-references. The federal citations in this chapter correspond to provisions of the Wisconsin administrative code and Wisconsin statutes. The federal citations may be cross-referenced in the following table: NR 283.40 HistoryHistory: Cr. Register, October, 1987, No. 382, eff. 11-1-87.
