Wisconsin Legislature: NR 262.22(1)

NR 262.03(1)(b)(b) The owner or operator of the porcelain enameling facility certifies in writing to the control authority that chromium is not contained in the raw materials or process chemicals of that facility and will not be used in the facility.

NR 262.03(2)(2) The “monthly average” regulatory values shall be the basis for the monthly average discharge in direct discharge permits and for pretreatment standards. Compliance with the monthly discharge limit is required regardless of the number of samples analyzed and averaged.

NR 262.03 HistoryHistory: Cr. Register, October, 1986, No. 370, eff. 11-1-86.

NR 262.04NR 262.04 Compliance date for pretreatment standards for existing sources (PSES). The compliance date for pretreatment standards for existing sources is November 25, 1985.

NR 262.04 HistoryHistory: Cr. Register, October, 1986, No. 370, eff. 11-1-86.

NR 262.10NR 262.10 Applicability; description of the steel basis material subcategory. This subcategory applies to discharges to waters of the state and introduction of pollutants into publicly owned treatment works from porcelain enameling on steel basis materials.

NR 262.10 HistoryHistory: Cr. Register, October, 1986, No. 370, eff. 11-1-86.

NR 262.11NR 262.11 Effluent limitations representing the degree of effluent reduction attainable by the application of the best practicable control technology currently available. Except as provided in 40 CFR 125.30 to 125.32, any existing point source subject to this subcategory shall achieve the following effluent limitations for metal preparation operations and for coating operations representing the degree of effluent reduction attainable by the application of the best practicable control technology currently available (BPT):

NR 262.11 Note1Within the range 7.5 to 10.0.

NR 262.11 HistoryHistory: Cr. Register, October, 1986, No. 370, eff. 11-1-86.

NR 262.12NR 262.12 Effluent limitations representing the degree of effluent reduction attainable by the application of the best available technology economically achievable. Except as provided in 40 CFR 125.30 to 125.32 any existing point source subject to this subcategory shall achieve the following effluent limitations representing the degree of effluent reduction attainable by the application of the best available technology economically achievable:

NR 262.12 HistoryHistory: Cr. Register, October, 1986, No. 370, eff. 11-1-86.

NR 262.13NR 262.13 New source performance standards. Any new source subject to this subcategory shall achieve the following new source performance standards:

NR 262.13 Note1 Within the range 7.5 to 10.0.

NR 262.13 HistoryHistory: Cr. Register, October, 1986, No. 370, eff. 11-1-86.

NR 262.14NR 262.14 Pretreatment standards for existing sources.

NR 262.14(1)(1) Except as provided in 40 CFR 403.7 and 403.13, any existing source subject to this subcategory which introduces pollutants into a publicly owned treatment works shall comply with 40 CFR Part 403 and achieve the following pretreatment standards for existing sources.

NR 262.14(2)(2) In cases where POTWs find it necessary to impose mass effluent pretreatment standards the following equivalent mass standards are provided:

NR 262.14 HistoryHistory: Cr. Register, October, 1986, No. 370, eff. 11-1-86.

NR 262.15NR 262.15 Pretreatment standards for new sources. Except as provided in 40 CFR 403.7 and 403.13, any new source subject to this subcategory which introduces pollutants into a publicly owned treatment works shall comply with 40 CFR Part 403 and achieve the following pretreatment standards for new sources:

NR 262.15 HistoryHistory: Cr. Register, October, 1986, No. 370, eff. 11-1-86.

NR 262.20NR 262.20 Applicability; description of the cast iron basis material subcategory. This subcategory applies to discharges to waters of the state and introductions of pollutants into publicly owned treatment works from porcelain enameling of cast iron basis materials.

NR 262.20 HistoryHistory: Cr. Register, October, 1986, No. 370, eff. 11-1-86.

NR 262.21NR 262.21 Effluent limitations representing the degree of effluent reduction attainable by the application of the best practicable control technology currently available. Except as provided in 40 CFR 125.30 to 125.32, any existing point source subject to this subcategory shall achieve the following effluent limitations representing the degree of effluent reduction attainable by the application of the best practicable control technology currently available:

NR 262.21(1)(1) There may not be discharge of process wastewater pollutants from metal preparation operations.

NR 262.21(2)(2) The discharge of process wastewater pollutants from all porcelain enameling coating operations may not exceed the values set forth below:

NR 262.21 Note1Within the range 7.5 to 10.0.

NR 262.21 HistoryHistory: Cr. Register, October, 1986, No. 370, eff. 11-1-86.

NR 262.22NR 262.22 Effluent limitations representing the degree of effluent reduction attainable by the application of the best available technology economically achievable. Except as provided in 40 CFR 125.30 to 125.32, any existing point source subject to this subcategory shall achieve the following effluent limitations representing the degree of effluent reduction attainable by the application of the best available technology economically achievable:

NR 262.22(1)(1) There may not be discharge of process wastewater pollutants from metal preparation operations.

NR 262.22(2)(2) The discharge of process wastewater pollutants from all porcelain enameling coating operations may not exceed the values set forth below:

NR 262.22 HistoryHistory: Cr. Register, October, 1986, No. 370, eff. 11-1-86.

NR 262.23NR 262.23 New source performance standards. Any new source subject to this subcategory shall achieve the following new source performance standards:

NR 262.23(1)(1) There may not be discharge of process wastewater pollutants from metal preparation operations.

NR 262.23(2)(2) The discharge of process wastewater pollutants from all porcelain enameling coating operations may not exceed the values set forth below:

NR 262.23 Note1Within the range 7.5 to 10.0.

NR 262.23 HistoryHistory: Cr. Register, October, 1986, No. 370, eff. 11-1-86.

NR 262.24NR 262.24 Pretreatment standards for existing sources.

NR 262.24(1)(1) Except as provided in 40 CFR 403.7 and 403.13, any existing source subject to this subcategory which introduces pollutants into a publicly owned treatment works shall comply with 40 CFR Part 403 and achieve the following pretreatment standards for existing sources:

NR 262.24(1)(a)(a) There may not be discharge of process wastewater pollutants from metal preparation operations.

NR 262.24(1)(b)(b) The discharge of process wastewater pollutants from all porcelain enameling coating operations may not exceed the values set forth below:

NR 262.24(2)(2) In cases where POTWs find it necessary to impose mass pretreatment standards the following equivalent mass standards are provided:

NR 262.24(2)(a)(a) There may not be discharge of process wastewater pollutants from metal preparation operations.

NR 262.24(2)(b)(b) The discharge of process wastewater pollutants from all porcelain enameling coating operations may not exceed the values set forth below:

NR 262.24 HistoryHistory: Cr. Register, October, 1986, No. 370, eff. 11-1-86.

NR 262.25NR 262.25 Pretreatment standards for new sources. Except as provided in 40 CFR 403.7, any new source subject to this subcategory which introduces pollutants into a publicly owned treatment works shall comply with 40 CFR Part 403 and achieve the following pretreatment standards for new sources.

NR 262.25(1)(1) There may not be discharge of process wastewater pollutants from metal preparation operations.

NR 262.25(2)(2) The discharge of process wastewater pollutants from all porcelain enameling coating operations may not exceed the values set forth below:

NR 262.25 HistoryHistory: Cr. Register, October, 1986, No. 370, eff. 11-1-86.

NR 262.30NR 262.30 Applicability; description of the aluminum basis material subcategory. This subcategory applies to discharges to waters of the state and introductions of pollutants into publicly owned treatment works from porcelain enameling of aluminum basis materials.

NR 262.30 HistoryHistory: Cr. Register, October, 1986, No. 370, eff. 11-1-86.

NR 262.31NR 262.31 Effluent limitations representing the degree of effluent reduction attainable by the application of the best practicable control technology currently available. Except as provided in 40 CFR 125.30 to 125.32, any existing point source subject to this subcategory shall achieve the following effluent limitations representing the degree of effluent reduction attainable by the application of the best available technology economically achievable:

NR 262.31 Note1Within the range 7.5 to 10.0.

NR 262.31 HistoryHistory: Cr. Register, October, 1986, No. 370, eff. 11-1-86.

NR 262.32NR 262.32 Effluent limitations representing the degree of effluent reduction attainable by the application of the best available technology economically achievable. Except as provided in 40 CFR 125.30 to 125.32, any existing point source subject to this subcategory shall achieve the following effluent limitations representing the degree of effluent reduction attainable by the application of the best available technology economically achievable.

NR 262.32 HistoryHistory: Cr. Register, October, 1986, No. 370, eff. 11-1-86.

NR 262.33NR 262.33 New source performance standards. Any new source subject to this subcategory shall achieve the following new source performance standards:

NR 262.33 Note1Within the range 7.5 to 10.0.

NR 262.33 HistoryHistory: Cr. Register, October, 1986, No. 370, eff. 11-1-86.

NR 262.34NR 262.34 Pretreatment standards for existing sources.

NR 262.34(1)(1) Except as provided in 40 CFR 403.7 and 403.13, any existing source subject to this subcategory which introduces pollutants into a publicly owned treatment works shall comply with 40 CFR Part 403 and achieve the following pretreatment standards for existing sources:

NR 262.34(2)(2) In cases where POTWs find it necessary to impose mass pretreatment standards the following equivalent mass standards are provided:

NR 262.34 HistoryHistory: Cr. Register, October, 1986, No. 370, eff. 11-1-86.

NR 262.35NR 262.35 Pretreatment standards for new sources. Except as provided in 40 CFR 403.7, any new source subject to this subcategory which introduces pollutants into a publicly owned treatment works shall comply with 40 CFR Part 403 and achieve the following pretreatment standards for new sources:

NR 262.35 HistoryHistory: Cr. Register, October, 1986, No. 370, eff. 11-1-86.

NR 262.40NR 262.40 Applicability; description of the copper basis material subcategory. This subcategory applies to discharges to waters of the state and introductions of pollutants into publicly owned treatment works from porcelain enameling of copper basis materials.

NR 262.40 HistoryHistory: Cr. Register, October, 1986, No. 370, eff. 11-1-86.

NR 262.43NR 262.43 New source performance standards. Any new source subject to this subcategory shall achieve the following new source performance standards:

NR 262.43 Note1Within the range 7.5 to 10.0.

NR 262.43 HistoryHistory: Cr. Register, October, 1986, No. 370, eff. 11-1-86.

NR 262.45NR 262.45 Pretreatment standards for new sources. Any new source subject to this subcategory which introduces pollutants into a publicly owned treatment works shall comply with 40 CFR Part 403 and achieve the following pretreatment standards for new sources:

NR 262.45 HistoryHistory: Cr. Register, October, 1986, No. 370, eff. 11-1-86.

NR 262.50NR 262.50 Cross-references. The federal citations in this chapter correspond to provisions of the Wisconsin Administrative Code and Wisconsin Statutes. The federal citations may be cross-referenced in the following table:

NR 262.50 HistoryHistory: Cr. Register, October, 1986, No. 370, eff. 11-1-86.