NR 106.145(4)(c)(c) The term of an alternative mercury effluent limitation may not extend beyond the term of the permit. NR 106.145(4)(d)(d) An alternative mercury effluent limitation may be renewed using the procedures and requirements in subs. (5) to (8). An alternative mercury effluent limitation may not be renewed if the permittee did not substantially comply with all of the mercury-regulation conditions of the previous permit. NR 106.145(5)(5) Calculation of an alternative mercury effluent limitation. NR 106.145(5)(a)(a) An alternative mercury effluent limitation shall equal the upper 99th percentile of representative daily discharge concentrations as calculated under s. NR 106.05 (4) (a), except as provided in par. (c). NR 106.145(5)(b)(b) The alternative mercury effluent limitation shall be expressed as a daily maximum concentration. NR 106.145(5)(c)(c) An alternative mercury effluent limitation may not be greater than the alternative mercury effluent limitation contained in the previous permit, unless the permittee demonstrates that the previous alternative mercury effluent limitation was based on monitoring that did not represent actual discharge concentrations. NR 106.145(6)(6) Department action on alternative mercury effluent limitation applications. NR 106.145(6)(a)(a) The department shall establish an alternative mercury effluent limitation for a discharger when all of the following have been met: NR 106.145(6)(a)1.1. The information provided in the alternative mercury effluent limitation application described in sub. (8) supports establishing the alternative mercury effluent limitation. NR 106.145(6)(a)2.2. The permittee and the department agree upon the alternative mercury effluent limitation and the specific permit language requiring implementation of the pollution minimization program described in sub. (7). NR 106.145(6)(b)(b) If the information provided in the alternative mercury effluent limitation application does not support establishing an alternative mercury effluent limitation or if the department and the permittee cannot agree on the alternative mercury effluent limitation and the specific permit language incorporating the pollutant minimization program, the department shall include the water quality based effluent limitation or limitations in the permit. This paragraph does not prohibit the department from seeking and the applicant providing supplemental information after the initial application is submitted. NR 106.145(6)(c)(c) If the department grants an alternative mercury effluent limitation, the permit shall require monitoring subject to the data quality requirements of subs. (9) and (10), at the following locations: NR 106.145(6)(c)2.2. Influent and sludge or biosolids for major and minor municipal discharges. NR 106.145(7)(a)(a) If the department grants an alternative mercury effluent limitation under sub. (6), the reissued permit shall require the permittee to implement a pollutant minimization program as defined in s. NR 106.04 (5) and detailed for mercury in this subsection. NR 106.145(7)(b)(b) If the reissued permit requires monthly data generation under sub. (3) (a) 1. or 4., the permit shall contain a special condition that triggers a pollutant minimization program if the first 24 months of data demonstrate that a limit will be necessary under sub. (2). The permit shall also require that the permittee do all of the following: NR 106.145(7)(b)1.1. Submit to the department within 36 months of permit reissuance a pollutant minimization program plan meeting the requirements specified in this subsection. NR 106.145(7)(b)2.2. Implement the pollutant minimization program following submittal of the plan. NR 106.145(7)(b)3.3. Submit the first annual status report required in par. (g) within 48 months of permit reissuance. NR 106.145(7)(c)(c) For municipal permittees, a pollutant minimization program shall consist of all of the following elements: NR 106.145(7)(c)2.2. Activities to help educate the general public, health professionals, school teachers, laboratory personnel or other professionals about ways to reduce use of mercury-containing products, recycle mercury-containing products and prevent spills. NR 106.145(7)(c)3.3. A program for collecting mercury from the permittee’s sewer system users. This program may be independently operated by the permittee, jointly by the permittee and others or by another governmental unit. NR 106.145(7)(c)4.4. Other activities that the department, in consultation with the permittee, deems appropriate for the individual permittee’s circumstances. NR 106.145(7)(d)(d) For industrial permittees, a pollutant minimization program may consist of any of the following elements: NR 106.145(7)(d)3.3. Substitution of raw materials or chemical additives with low-mercury alternatives. NR 106.145(7)(e)(e) In assessing the appropriate elements for a pollutant minimization program, the department may consider any of the following: NR 106.145(7)(e)3.3. The level of mercury in the effluent, influent and biosolids or sludge. NR 106.145(7)(e)5.5. The environmental costs and benefits of the pollutant minimization program elements. NR 106.145(7)(e)6.6. The characteristics of the community in which the discharger is located. NR 106.145(7)(e)8.8. The opportunities available for support from or cooperation with other organizations. NR 106.145(7)(e)9.9. The actions the discharger has taken in the past to reduce mercury use or discharges. NR 106.145(7)(f)(f) The pollutant minimization program plan shall include all of the following: NR 106.145(7)(f)1.1. Identify specific activities to be undertaken and a relative timeline to implement those activities. NR 106.145(7)(f)2.2. State which, if any, activities have already been implemented and how effective they were in reducing potential and actual mercury discharges. NR 106.145(7)(f)3.3. Commit the permittee to document how the pollutant minimization program plan was implemented including measures such as the number of contacts of various types made, programs implemented and other activities. NR 106.145(7)(f)4.4. Provide for steps to measure the effectiveness of the pollution minimization program elements in reducing potential and actual mercury discharges. Where the permittee regularly monitors influent, effluent, sludge or biosolids for mercury, measures shall include any changes in mercury concentrations over comparable historic data. Where practicable, other measures or estimates of mercury reductions from programs such as mercury recycling, collection or disposal may also be included. NR 106.145(7)(g)(g) Within 12 months of the beginning of implementation of the pollutant minimization program and annually thereafter, the permittee shall report to the department on the progress of the pollutant minimization program as required in s. NR 106.04 (5). This annual report shall include all of the following: NR 106.145(7)(g)1.1. An evaluation of the effectiveness of the program in accordance with the plan. NR 106.145(7)(g)2.2. Identification of barriers that have limited program effectiveness and adjustments to the program that will be implemented during the next year to help address these barriers. NR 106.145(7)(h)(h) Permittees may collaborate with one another or other parties to plan and implement a pollutant minimization program. NR 106.145 NoteNote: Permittees that do not prepare or effectively implement a pollutant minimization program are subject to regulatory requirements for mercury, without alternative mercury effluent limitations to water quality standards. For municipal permittees this may mean development and enforcement of mercury discharge standards for users of the public sewerage system pursuant to s. NR 211.10 (3). For users of the municipal sewerage system this may mean changes in processes, installation of treatment technology, or other means to comply with the municipal mercury discharge standards pursuant to s. NR 211.10 (1). Implementation of the municipal mercury discharge standards may require a program of user discharge permits and wastewater discharge monitoring. NR 106.145(8)(8) Alternative mercury effluent limitation applications. NR 106.145(8)(a)(a) To apply for an alternative mercury effluent limitation under this section, a permittee shall do all of the following: NR 106.145(8)(a)1.1. Submit an alternative mercury effluent limitation application at the same time as the application for permit reissuance following data generation. NR 106.145(8)(a)2.2. State the basis for concluding that wastewater treatment technology for mercury is impractical. NR 106.145(8)(a)3.3. Supply representative effluent monitoring results of sufficient number and analytical sensitivity to quantify with reasonable certainty the concentration and mass of mercury discharged. Representative sample results shall meet all of the following requirements: NR 106.145(8)(b)(b) A permittee applying for renewal of an alternative mercury effluent limitation previously granted shall follow the procedures in par. (a) except for all of the following: NR 106.145(8)(b)1.1. The permittee shall submit information indicating whether the permittee substantially complied with mercury regulation conditions of the existing permit. NR 106.145(8)(b)2.2. A new pollutant minimization program plan shall re-evaluate the plan required under the previous permit. NR 106.145(9)(a)(a) Sample types may be grab or 24-hour composite. “Grab sample” and “24-hour composite sample” have the meanings specified in s. NR 218.04. NR 106.145(9)(b)(b) Sample collection methods shall be consistent with EPA Method 1669: Sampling Ambient Water for Trace Metals at EPA Water Quality Criteria Levels, EPA-821-R-96-011. NR 106.145(9)(c)(c) Requirements for field blanks are as follows. A field blank means an aliquot of mercury-free reagent water that is placed in a sample container, shipped to the field and treated as a sample in all respects, including contact with the sampling devices and exposure to sampling site conditions, filtration, storage, preservation, and all analytical procedures. The purpose of the field blank is to determine whether the field or sample transporting procedures and environments have contaminated the sample: NR 106.145(9)(c)1.1. At least one field blank shall be collected at each site for each day a sample is collected. If more than one sample is collected in a day, at least one field blank for each 10 samples collected on that day shall be collected. NR 106.145(9)(c)2.2. If mercury or any potentially interfering substance is found in the field blank at a concentration equal to or greater than 0.5 ng/L, the limit of detection or one-fifth the level in the associated sample, whichever is greater, results for associated samples may not be used for regulatory compliance purposes unless the conditions in subd. 3. are met. NR 106.145(9)(c)3.3. If at least 3 field blanks are collected on a day when samples are collected and the average mercury concentration of the field blanks plus 2 standard deviations is less than or equal to one-half of the level in the associated sample or less than the lowest water quality criterion for mercury found in ch. NR 105, whichever is greater, results may be used. NR 106.145 NoteNote: As of November 1, 2002 the lowest water quality criterion listed in ch. NR 105 is 1.3 ng/L. NR 106.145(9)(c)4.4. Once a permittee demonstrates the ability to collect samples from a given site using an established procedure that meets the use-criteria of subd. 2., the permittee may decrease the number of field blanks to no fewer than one field blank for each 4 sampling days. NR 106.145(9)(c)4.a.a. The initial demonstration shall consist of at least 6 consecutive sampling days. NR 106.145(9)(c)4.b.b. If the permittee makes significant changes to the sampling procedure or sampling personnel, the 6-day demonstration shall be repeated. NR 106.145(9)(c)4.c.c. If after reducing the field blank frequency, a field blank fails to meet the use-criteria, the permittee shall take corrective action and return to collecting field blanks on each sampling day until it can meet the use-criteria for at least 3 consecutive sampling days. NR 106.145(9)(c)4.d.d. In no case may the permittee decrease field blanks to fewer than one for each 10 samples. NR 106.145(9)(c)5.5. The permittee shall report, but may not subtract, field blank concentrations when reporting sample results. NR 106.145 NoteNote: When using the data, the department may subtract field blanks from sample concentrations on a case-by-case basis.
NR 106.145 NoteNote: “Matrix spike” has the meaning specified in EPA Method 1631, Revision E: Mercury in Water by Oxidation, Purge and Trap, and Cold Vapor Atomic Fluorescence Spectrometry, August 2002, Office of Water, EPA-821-R-02-019.
NR 106.145(10)(b)(b) The analytical method used shall be sensitive enough to quantify mercury concentrations in the sample or mercury concentrations down to the lowest water quality criterion found in ch. NR 105, whichever is greater. NR 106.145(10)(c)(c) The department may exempt a permittee from the sensitivity requirement in par. (b) if the permittee can demonstrate to the department’s satisfaction that the specific effluent matrix does not allow this level of sensitivity using the most sensitive approved method with all reasonable precautions. NR 106.145(10)(d)(d) The laboratory performing the analyses shall be certified for mercury under the cold vapor atomic fluorescence spectrophotometry technology of ch. NR 149. NR 106.145(10)(e)(e) Method blanks analyzed concurrently with samples shall be reported with sample results. Method blanks may be subtracted from sample results unless concentrations of mercury in the method blank exceed the laboratory’s limit of detection, 0.5 ng/L or 5% of the sample concentration, whichever is greater. NR 106.145(10)(f)(f) Matrix spikes analyzed concurrently with samples shall have recoveries between 71 and 125%. NR 106.145(11)(11) Data rejection. The department may reject any sample results if data quality requirements specified in subs. (9) and (10) are not met or if results are produced by a laboratory that is not in compliance with requirements specified in ch. NR 149. NR 106.145(12)(12) Applicability of the variance process under s. 283.15, Stats. If a water quality based effluent limitation is included in a permit under sub. (6) (b), a permittee may apply to the department for a variance from the water quality standard used to derive the limitation following the procedure specified in s. 283.15, Stats. Where a permittee has been granted an alternative mercury effluent limitation under this section, the procedures of s. 283.15, Stats., are not applicable.
/exec_review/admin_code/nr/100/106
true
administrativecode
/exec_review/admin_code/nr/100/106/iii/145/7/d/4
Department of Natural Resources (NR)
Chs. NR 100-199; Environmental Protection – General
administrativecode/NR 106.145(7)(d)4.
administrativecode/NR 106.145(7)(d)4.
section
true
