Trans 301.29(5)
(5) Rear or center facing seats in a station wagon are not permitted.
Trans 301.29 History
History: Cr.
Register, March, 1982, No. 315, eff. 4-1-82; am. (2) and (4), r. and recr. (3), cr. (5),
Register, April, 1997, No. 496, eff. 5-1-97.
Trans 301.30(2)
(2) Service door shall be so designed as to prevent accidental opening.
Trans 301.30(3)
(3) In a vehicle of more than 10,000 pounds GVWR, the lower as well as upper panels shall be of safety glass as follows:
Trans 301.30(3)(a)
(a) The bottom of the lower glass panel may not be more than 35 inches from the ground when vehicle is unloaded.
Trans 301.30(3)(b)
(b) The upper glass shall be hermetically sealed or the vehicle shall be equipped with a defrosting device to assure the driver has a clear view out of the service door glass.
Trans 301.30 History
History: Cr.
Register, March, 1982, No. 315, eff. 4-1-82; renum. (1) to be Trans 301.03 (8) and am., renum. (2) to (4) to be (1) to (3) and am. (3),
Register, April, 1997, No. 496, eff. 5-1-97.
Trans 301.31
Trans 301.31 Steering. All components and linkages for the steering system shall be properly maintained.
Trans 301.31 History
History: Cr.
Register, March, 1982, No. 315, eff. 4-1-82.
Trans 301.32(1)(1)
The first step at the service door shall be not more than 18 inches above the ground when the vehicle is empty. The use of a portable step may not be considered in meeting this requirement.
Trans 301.32(2)
(2) The riser of the upper step at the service door shall be not more than 15 inches.
Trans 301.32(3)
(3) A grab handle not less than 10 inches in length shall be provided in an unobstructed location inside doorway to assist a person entering or leaving a HSV.
Trans 301.32(4)
(4) The surface of the steps shall be of nonskid material or construction.
Trans 301.32 History
History: Cr.
Register, March, 1982, No. 315, eff. 4-1-82; am. (1),
Register, April, 1997, No. 496, eff. 5-1-97.
Trans 301.33
Trans 301.33 Suspension system. In addition to conforming to the requirements under
49 CFR 393.207, all suspension parts, including mountings, shackles, U-bolts, airbags and all connecting air lines shall be maintained in good working order.
Trans 301.33 History
History: Cr.
Register, March, 1982, No. 315, eff. 4-1-82; r. and recr.
Register, April, 1997, No. 496, eff. 5-1-97.
Trans 301.34(1)(1)
The front and rear tires shall have tread depth of at least 2/32 inch around the entire periphery measured at 2 points no less than 15 inches apart in any major tread groove. Vehicles with a GVWR of more than 10,000 pounds shall have front tires with a minimum of 4/32 inch tread depth and rear tires with a minimum of 2/32 inch tread depth.
Trans 301.34(2)
(2) An HSV may not be operated with regrooved, recapped or retreaded tires on the front wheels.
Trans 301.34(3)
(3) An HSV may not be operated with cuts or chunks missing exposing the cord, recaps peeled loose or off, or showing an indication of ply separation.
Trans 301.34(4)
(4) Tires of different size or ply rating may be used except that all tires on an axle shall be the same size and ply rating.
Trans 301.34 History
History: Cr.
Register, March, 1982, No. 315, eff. 4-1-82; am. (2) to (4),
Register, April, 1997, No. 496, eff. 5-1-97.
Trans 301.35(1)
(1) All windows that open shall operate freely. Any side window latches shall be capable of holding the window securely in place in all positions.
Trans 301.35(2)
(2) All exposed edges shall be banded or ground to eliminate sharp or rough areas.
Trans 301.35(3)
(3) If an emergency window is originally equipped with an automatically operated, audible signal to indicate to the driver that the window is unlatched when the ignition is in the “on" position, no cut-off may be installed in the audible signal circuit.
Trans 301.35 History
History: Cr.
Register, March, 1982, No. 315, eff. 4-1-82; r. and recr.
Register, April, 1997, No. 496, eff. 5-1-97.
Trans 301.36(1)(1)
In addition to the requirements for windshield wipers under
49 CFR 393.78, the windshield wiper system shall have at least 2 speeds or a variable speed motor.
Trans 301.36(2)
(2) If an HSV is originally equipped with a windshield washer system that provides fluid for the windshield wipers to clean the windshield, the system shall be maintained in operational condition.
Trans 301.36 History
History: Cr.
Register, March, 1982, No. 315, eff. 4-1-82; r. and recr.
Register, April, 1997, No. 496, eff. 5-1-97.
Trans 301.37 History
History: Cr.
Register, March, 1982, No. 315, eff. 4-1-82; r. and recr.
Register, April, 1997, No. 496, eff. 5-1-97.
Trans 301.60(1)(1)
Vehicles used for transporting persons with a disability shall comply with current Wisconsin statutes and rules except for modifications necessary for the installation of special equipment. Such modifications or exceptions are set forth in this section through s.
Trans 301.66. In addition, new, used or remanufactured buses and vans placed in operation after February 25, 1992, and used to transport persons with disabilities shall comply with all requirements in
36 CFR 1192, subparts A and B.
Trans 301.60(2)
(2) Any HSV used for transporting persons with a disability in wheelchairs shall be equipped with a side ramp or a lift located on the right side of the body. The side ramp or lift may not be attached to the exterior of the body, but shall be completely contained and securely fastened within the perimeter of the vehicle body when not in operation. An HSV equipped with a ramp or a lift using the HSV rear door may not be used to load or discharge persons on a highway as defined by s.
340.01 (22), Stats., or where otherwise prohibited. An HSV need not be equipped with a side ramp or lift located on the right side of the body.
Trans 301.60 History
History: Cr.
Register, March, 1982, No. 315, eff. 4-1-82; emerg. am. (2), eff. 6-29-83; am. (2),
Register, December, 1983, No. 336, eff. 1-1-84; am.
Register, April, 1997, No. 496, eff. 5-1-97;
CR 22-048: am. (1) Register July 2023 No. 811, eff. 8-1-23.
Trans 301.61(1)(1)
There shall be an enclosed door opening located on the right side of the HSV and far enough to the rear so that any forward mounted door when fully opened may not obstruct or interfere with the normal operation of the regular service door.
Trans 301.61(2)
(2) A device shall be provided to hold doors in a wide open position of at least 90
°.
Trans 301.61(3)
(3) Door materials and structural strength shall be equivalent to conventional service and emergency doors.
Trans 301.61(5)
(5) The door shall be equipped with a device that shall actuate an audible or visual signal located in the driver's compartment when door is not securely closed and latched and may deactivate when door is fully opened. This subsection shall be applicable to vehicles manufactured after January 1, 1982.
Trans 301.61(6)
(6) Door panels shall enclose the complete opening in the body made necessary by the installation of a side ramp or power lift.
Trans 301.61 History
History: Cr.
Register, March, 1982, No. 315, eff. 4-1-82;
am. (1), (5) and (6),
Register, April, 1997, No. 496, eff. 5-1-97.
Trans 301.62(1)(1)
The lifting mechanism shall have a minimum capacity of 700 pounds.
Trans 301.62(4)
(4) Lift platform edges shall be designed to prevent wheelchairs or attendant's feet from becoming entangled during raising and lowering process.
Trans 301.62(5)
(5) The platform floor surface shall be of nonskid material.
Trans 301.62(6)
(6) The platform shall lock mechanically when in the stored position. A power lift designed to remain in a rigid position with the power off is exempt from having a mechanical lock. The intent of this subsection is to prevent a lift from having any movement while the vehicle is in motion.
Trans 301.62(7)
(7) Up and down limits shall be controlled by limit switch or by-pass valve. A lift with gravity lowering capabilities is exempt from having a by-pass valve.
Trans 301.62(8)
(8) Positioning power lift shall be controlled by switches which give the operator instant and positive control to move, stop, or reverse the lift travel at will.
Trans 301.62(9)
(9) With the exception of floor molding, no metal screws are to be used in fabrication of platform assembly.
Trans 301.62(10)
(10) The lift control shall be interlocked with the vehicle brakes, transmission or door, or shall provide other appropriate mechanisms or systems, to ensure that the vehicle cannot be moved when the lift is not stowed and so the lift cannot be deployed unless the interlocks or systems are engaged.
Trans 301.62(11)
(11) New, used or remanufactured buses and vans placed in operation after February 25, 1992, and used to transport persons with physical disabilities shall comply with the requirements found in
36 CFR 1192.21 and
1192.23.
Trans 301.62 History
History: Cr.
Register, March, 1982, No. 315, eff. 4-1-82; am. (2), (5) and (6), cr. (10) and (11),
Register, April, 1997, No. 496, eff. 5-1-97;
CR 22-048-: am. (11) Register July 2023 No. 811, eff. 8-1-23.
Trans 301.63(1)(1)
A floor ramp shall be covered with nonskid material. A ramp when in the stored position shall be locked by a mechanical device to prevent its movement while the vehicle is in motion.
Trans 301.63(2)
(2) New, used or remanufactured buses and vans placed in operation after February 25, 1992, and used to transport persons with physical disabilities shall comply with the requirements found in
36 CFR 1192.21 and
1192.23.
Trans 301.63 History
History: Cr.
Register, March, 1982, No. 315, eff. 4-1-82; renum. to be (1), cr. (2),
Register, April, 1997, No. 496, eff. 5-1-97;
CR 22-048: am. (2) Register July 2023 No. 811, eff. 8-1-23. Trans 301.64(1)(1)
Barriers shall be furnished to provide a restraint for passengers. If the vehicle is a van and has only seats with no area for wheelchairs, it is exempt from having barriers. The most forward seat behind an open area for wheelchair use and the most forward seat behind a power lift or ramp shall be protected by a barrier. This subsection does not apply to vehicles equipped with seat belts and shoulder restraints that meet
49 CFR 571.208, occupant crash protection requirements, and that are used in accordance with s.
347.48, Stats.
Trans 301.64(2)
(2) All inside and rear facing surfaces except the platform surface of a lift shall be padded. Barriers and stanchions shall be padded.
Trans 301.64 History
History: Cr.
Register, March, 1982, No. 315, eff. 4-1-82; am.
Register, April, 1997, No. 496, eff. 5-1-97.
Trans 301.65(1)(1)
Each wheelchair shall be secured to the vehicle before the vehicle moves from the parked position with a fastening device with sufficient strength to:
Trans 301.65(1)(c)
(c) Prevent the chair's wheels from leaving the floor in the event of a sudden stop or start.
Trans 301.65(2)
(2) The device may be either a metal locking unit that secures the wheelchair to the wall or floor or a webbing belt system that accomplishes the same purpose.
Trans 301.65(4)
(4) If a webbing belt system is used it shall be secured to the vehicle at not less than 2 points with bolts, nuts, and lock washers or self-locking nuts, or with a positive latching mechanism of matching interlocking units which permits the belt portion to be removed and stored. The webbing system shall be free of any tears or damage to the locking mechanism.
Trans 301.65(5)
(5) A webbing belt used to secure the wheelchair to the body frame may not be used to secure the passenger to the wheelchair.
Trans 301.65 History
History: Cr.
Register, March, 1982, No. 315, eff. 4-1-82; am. (3) and (5),
Register, April, 1997, No. 496, eff. 5-1-97.
Trans 301.66(1)(1)
Seat frames may be equipped with a device to which belts or restraining harnesses may be attached.
Trans 301.66(2)
(2) Every occupant shall be secured to the wheelchair while being transported.
Trans 301.66(3)
(3) Vehicles manufactured and placed in operation prior to August 25, 1990, that are designed to transport wheelchairs may have aisle facing seats over the wheel housing provided they are equipped with a device to prevent a passenger from sliding off either end. A seat belt may not in itself meet this requirement. The seat shall be permanently mounted and may not fold up or down.
Trans 301.66 History
History: Cr.
Register, March, 1982, No. 315, eff. 4-1-82; am. (3),
Register, April, 1997, No. 496, eff. 5-1-97.
Trans 301.95(1)(1)
Any item if covered by a standard in this chapter shall, upon replacement, be replaced with an item meeting the original standard. Any modification of an HSV shall be made to conform to federal and state regulations at the time of modification.
