Trans 262.04 Eligibility.
Trans 262.06 Registration requirements.
Trans 262.07 Driver and operating requirements.
Trans 262.08 Maximum size, weight and loading limitations.
Trans 262.09 Equipment requirements.
Trans 262.10 Times of operation.
Trans 262.11 Power unit change.
Trans 262.12 Insurance and liability conditions.
Trans 262.13 General conditions and requirements.
Trans 262.14 Denial, suspension or revocation of permit.
Trans 262.01
Trans 262.01 Purpose. The purpose of this chapter is to establish standards and procedures for the issuance of backhaul permits, pursuant to s.
348.26 (6), Stats.
Trans 262.01 History
History: Cr.
Register, December, 1990, No. 420, eff. 1-1-91.
Trans 262.02(2)(a)
(a) “Backhaul" means to transport different loads by the same motor vehicle on the trip to its original destination and on its return trip.
Trans 262.02 History
History: Cr.
Register, December, 1990, No. 420, eff. 1-1-91.
Trans 262.03(1)(1)
An application for a permit shall be submitted to an issuing authority on a form approved by the department, and in accordance with s.
348.26, Stats.
Trans 262.03(2)
(2) An application for a permit for the use of a state trunk highway shall be made to the department in any of the following ways:
Trans 262.03 Note
Note: Permit application procedures are in s.
Trans 250.025 Trans 262.03 History
History: Cr.
Register, December, 1990, No. 420, eff. 1-1-91; correction in (2) (a) made under s.
13.92 (4) (b) 6., Stats.,
Register February 2013 No. 686.
Trans 262.04(1)(1)
An issuing authority may issue a permit for the transportation of a legal size and legal weight load on an oversize vehicle or combination of vehicles, provided that the vehicle or combination of vehicles has a multiple or single trip oversize permit for the transportation of an oversize load in the direction opposite to the backhaul permit and actually transports an oversize load in that direction.
Trans 262.04 Note
Note: Legal sizes are set forth in ch.
348 and s.
349.16, Stats.
Trans 262.04 Note
Note: As an example, if an overwide crawler tractor is transported under permit between a storage area and a job site, then a backhaul permit may be issued for the transportation of an industrial air compressor in the opposite direction.
Trans 262.04 Note
The overwide crawler must actually be transported. The 2 trips must be part of the same round trip by the permitted vehicle. The transportation of the air compressor may be in either direction, but must be in the direction opposite to that of the movement of the crawler. The transportation of the air compressor may precede or follow in time the transportation of the crawler tractor.
Trans 262.04(2)
(2) A permit may not authorize the operation of more than 2 vehicles in combination.
Trans 262.04(3)
(3) An issuing authority may issue a permit only for a vehicle equipped with pneumatic tires.
Trans 262.04(4)
(4) A permit is not a guarantee of the sufficiency of any highway or structure for the transporting of the vehicle, load, or vehicle and load.
Trans 262.04 History
History: Cr.
Register, December, 1990, No. 420, eff. 1-1-91.
Trans 262.05(1)(1)
A permit is valid only for the vehicle described in the application and permit.
Trans 262.05(2)
(2) A permit is valid only on the route specified in the permit.
Trans 262.05(3)
(3) An issuing authority may suspend a permit, or any of its conditions, because of seasonal highway conditions.
Trans 262.05 Note
Note: Examples of seasonal highway conditions include spring thaw, flooding, and traffic congestion.
Trans 262.05(4)
(4) No condition of a permit may modify any law or regulation limiting loads because of local conditions, including load limits on bridges and highways, seasonal weight restrictions, or load limits imposed because of construction.
Trans 262.05(5)
(5) A permit is not valid during periods when adverse weather or road conditions, such as fog, smoke, heavy rain, snow or ice, or wind velocity, impair the safety of a movement under the permit.
Trans 262.05 History
History: Cr.
Register, December, 1990, No. 420, eff. 1-1-91.
Trans 262.06(1)(1)
A vehicle operating under a permit shall be registered as required by Wisconsin statutes, and shall be registered at not less than the permit weight or at the maximum available registration weight, whichever is less.
Trans 262.06(2)
(2) All other operational permits required by the department or other agencies having jurisdiction shall be obtained.
Trans 262.06 History
History: Cr.
Register, December, 1990, No. 420, eff. 1-1-91; correction in (2) made under s. 13.93 (2m) (b) 6., Stats.,
Register, August, 1996, No. 488.
Trans 262.07
Trans 262.07 Driver and operating requirements. Trans 262.07(1)(1)
The driver of a vehicle operating under a permit shall carry the permit in the vehicle to which [it] applies and shall have the permit available for inspection by any police officer, representative of the issuing authority, or person in charge of the maintenance of the highway being used.
Trans 262.07(2)
(2) The driver of a vehicle operating under a permit shall carry proof that transportation of an oversize or overweight load has been made to the origin of the backhaul movement or will be made from the destination of the backhaul movement. This proof may be a freight bill, a bill of lading, or similar document, or a signed order from the employer ordering the driver to transport a specific oversize load between specified locations.
Trans 262.07(3)
(3) The driver of a vehicle operating under a permit shall, whenever reasonable and practicable, maintain a distance of not less than 1,000 feet between the vehicle with the permit and any vehicle the driver is following, unless actually engaged in overtaking and passing another vehicle.
Trans 262.07(4)
(4) The driver of a vehicle operating under a permit shall allow traffic approaching or overtaking the permitted vehicle to pass, where it is safe to do so.
Trans 262.07(5)
(5) Unless a lower speed is specified in the permit, a vehicle operating under a permit may be operated at the posted speed limit.
Trans 262.07(6)
(6) The right wheels of the towed unit may not leave the roadway, except to allow traffic to pass.
Trans 262.07 Note
Note: A “roadway" does not include paved or unpaved shoulders, s.
340.01 (54), Stats.
Trans 262.07 History
History: Cr.
Register, December, 1990, No. 420, eff. 1-1-91.
Trans 262.08
Trans 262.08 Maximum size, weight and loading limitations. Trans 262.08(1)(1)
A load transported under a permit may not be overweight.
Trans 262.08 History
History: Cr.
Register, December, 1990, No. 420, eff. 1-1-91.
Trans 262.09(1)(a)(a) When a vehicle or trailer is overlength, a single flag shall be fastened at each of the rear corners of the trailer.
Trans 262.09(1)(b)
(b) When a vehicle or trailer is overwidth, a flag shall be fastened at the left and right extremities of both the front and rear of the vehicle or trailer, whichever is wider.
Trans 262.09(1)(c)
(c) Each flag shall be solid red or orange in color, and not less than 18 inches square.
Trans 262.09(1)(d)
(d) In order to wave freely, flags shall be securely fastened by at least one corner or securely mounted on a staff.
Trans 262.09(2)(a)
(a) When a vehicle or trailer is more than 10 feet wide or is overlength, 2 warning signs shall be displayed. One sign shall be fastened at the front of the power unit and the other at either the rear of the towed unit or at the rear of the load.
Trans 262.09(2)(b)
(b) Each sign shall state, in black letters on a yellow background, “OVERSIZE LOAD," and may not be less than 7 feet long and 18 inches high. The letters of the sign may not be less than 10 inches high with a brush stroke of not less than 1.4 inches.
Trans 262.09(2)(c)
(c) The sign message may not be displayed when the vehicle is not operating under the permit.
Trans 262.09 History
History: Cr.
Register, December, 1990, No. 420, eff. 1-1-91.
Trans 262.10(1)(1)
Except as otherwise specified in a permit, no vehicle or vehicle combination operating under a permit that is equal to or less than 12 feet in width, 13
1⁄
2 feet in height, or 100 feet in length, may operate:
Trans 262.10(1)(b)
(b) Between 4:00 p.m. and 11:00 p.m. on Friday between the 4th Friday in May and Labor Day.
Trans 262.10(1)(c)
(c) Between 4:00 p.m. and 11:00 p.m. on any holiday, or, when Independence Day falls on Sunday, on the following Monday.
Trans 262.10(1)(d)
(d) Between 4:00 p.m. and 11:00 p.m. on the day before any holiday, except that this restriction does not apply to Independence Day when it falls on a Sunday.
Trans 262.10(2)
(2) In addition to the conditions provided in sub.
(1), no vehicle or vehicle combination operating under a permit that exceeds 12 feet in width, 13
1⁄
2 feet in height, or 100 feet in length, may operate:
Trans 262.10(2)(b)
(b) During the period beginning at 12:00 noon on the day preceding and continuing until sunrise on the day following every Sunday and holiday.
Trans 262.10(3)
(3) In addition to the conditions provided in subs.
(1) and
(2), no oversize vehicle or vehicle combination may operate on any part of the Milwaukee county expressway system constructed pursuant to s.
59.84, Stats.:
Trans 262.10(3)(a)
(a) Between 6:00 a.m. and 9:00 a.m. and between 3:00 p.m. and 6:00 p.m. on Monday through Thursday.
Trans 262.10(3)(b)
(b) Between 6:00 a.m. and 9:00 a.m. and between 3:00 p.m. and 11:00 p.m. on Friday and Sunday.
Trans 262.10(3a)
(3a) Subsection
(3) does not apply to U.S. highway 45 between West Florist Avenue and West Hampton Avenue or to interstate highway 94 between the Waukesha county line and 108th street.
Trans 262.10(4)
(4) An issuing authority may issue a permit for times other than those specified in subs.
(1),
(2), or
(3), under extraordinary circumstances when, in the opinion of the issuing authority, public health and welfare is better served, and may impose additional conditions to promote the safe operation of the vehicle and load.
