NR 283.21(1)(1) Except as provided in
40 CFR 125.30 to
125.32, any existing point source subject to this subchapter shall achieve the effluent limitations representing the degree of effluent reduction attainable by the application of BPT, which is calculated by multiplying the average process water usage flow rate for the cleaning water processes at a point source times the following pollutant concentrations:
-
See PDF for table 
NR 283.21(2)
(2) The department shall obtain the average process water usage flow rate for the cleaning water processes from the permittee.
NR 283.21 History
History: Cr.
Register, October, 1987, No. 382, eff. 11-1-87.
NR 283.22
NR 283.22 Effluent limitations representing the degree of effluent reduction attainable by the application of the best available technology economically achievable. Based on EPA's determination that BPT provides adequate control of toxic pollutants in cleaning process wastewater, BAT guidelines are equivalent to BPT guidelines.
NR 283.22 History
History: Cr.
Register, October, 1987, No. 382, eff. 11-1-87.
NR 283.23
NR 283.23 New source performance standards. NR 283.23(1)(1) Any new source subject to this subchapter shall achieve performance standards calculated by multiplying the average process water usage flow rate for cleaning processes at a new source times the pollutant concentrations indicated in Table 2.
NR 283.23(2)
(2) The department shall obtain the average process water usage flow rate for the new source cleaning water processes from the permittee.
NR 283.23 History
History: Cr.
Register, October, 1987, No. 382, eff. 11-1-87.
NR 283.24
NR 283.24 Pretreatment standards for existing sources. Any existing source subject to this subchapter that introduces pollutants into a POTW shall comply with
ch. NR 211.
NR 283.24 History
History: Cr.
Register, October, 1987, No. 382, eff. 11-1-87.
NR 283.25
NR 283.25 Pretreatment standards for new sources. Any new source subject to this subchapter that introduces pollutants into a POTW shall comply with
ch. NR 211.
NR 283.25 History
History: Cr.
Register, October, 1987, No. 382, eff. 11-1-87.
NR 283.30
NR 283.30 Applicability; description of the finishing water subcategory. This subchapter applies to the discharge of pollutants from processes in the finishing water subcategory to waters of the state and the introduction of pollutants into POTWs. The finishing water subcategory is limited to processes where process water contacts the plastic product for the purpose of removing waste plastic material or lubricating a plastic product during finishing.
NR 283.30 History
History: Cr.
Register, October, 1987, No. 382, eff. 11-1-87.
NR 283.31
NR 283.31 Effluent limitations representing the degree of effluent reduction attainable by the application of the best practicable control technology currently available. NR 283.31(1)(1) Except as provided in
40 CFR 125.30 to
125.32, any existing point source subject to this subchapter shall achieve the effluent limitations representing the degree of effluent reduction attainable by the application of BPT, which is calculated by multiplying the average process water usage flow rate for the finishing water processes at a point source times the following pollutant concentrations:
-
See PDF for table NR 283.31(2)
(2) The department shall obtain the average process water usage flow rate for the finishing water processes from the permittee.
NR 283.31 History
History: Cr.
Register, October, 1987, No. 382, eff. 11-1-87.
NR 283.32
NR 283.32 Effluent limitations representing the degree of effluent reduction attainable by the application of the best available technology economically achievable. Based on EPA's determination that BPT provides adequate control of toxic pollutants in finishing process wastewater, BAT guidelines are equivalent to BPT guidelines.
NR 283.32 Note
Note: BAT effluent limitations for bis(2-ethylhexyl) phthalate, di-n-butyl phthalate, and dimethyl phthalate are reserved.
NR 283.32 History
History: Cr.
Register, October, 1987, No. 382, eff. 11-1-87.
NR 283.33
NR 283.33 New source performance standards. NR 283.33(1)(1) Any new source subject to this subchapter shall achieve performance standards which are calculated by multiplying the average process water usage flow rate for the finishing water processes at a new source times the pollutant concentrations indicated in Table 3.
NR 283.33(2)
(2) The department shall obtain the average process water usage flow rate for the new source finishing water processes from the permittee.
NR 283.33 Note
Note: NSPS for bis(2-ethylhexyl) phthalate, di-n-butyl phthalate, and dimethyl phthalate are reserved.
NR 283.33 History
History: Cr.
Register, October, 1987, No. 382, eff. 11-1-87.
NR 283.34
NR 283.34 Pretreatment standards for existing sources. Any existing source subject to this subchapter that introduces pollutants into a POTW shall comply with
ch. NR 211.
NR 283.34 Note
Note: PSES for bis(2-ethylhexyl) phthalate, di-n-butyl phthalate, and dimethyl phthalate are reserved.
NR 283.34 History
History: Cr.
Register, October, 1987, No. 382, eff. 11-1-87.
NR 283.35
NR 283.35 Pretreatment standards for new sources. Any new source subject to this subchapter that introduces pollutants into a POTW shall comply with
ch. NR 211.
NR 283.35 Note
Note: PSNS for bis(2-ethylhexyl) phthalate, di-n-butyl phthalate, and dimethyl phthalate are reserved.
NR 283.35 History
History: Cr.
Register, October, 1987, No. 382, eff. 11-1-87.
NR 283.40
NR 283.40 Cross-references. The federal citations in this chapter correspond to provisions of the Wisconsin administrative code and Wisconsin statutes. The federal citations may be cross-referenced in the following table:
-
See PDF for table NR 283.40 History
History: Cr.
Register, October, 1987, No. 382, eff. 11-1-87.
