NR 151.055NR 151.055 Process wastewater handling performance standard. NR 151.055(1)(1) All livestock producers shall comply with this section. NR 151.055(2)(2) There may be no significant discharge of process wastewater to waters of the state. NR 151.055(3)(3) The department shall consider all of the following factors when determining whether a discharge of process wastewater is a significant discharge to waters of the state: NR 151.055(3)(c)(c) Means of process wastewater conveyance to waters of the state. NR 151.055(3)(d)(d) Slope, vegetation, rainfall, and other factors affecting the likelihood or frequency of process wastewater discharge to waters of the state. NR 151.055(3)(f)(f) Whether the process wastewater discharge is to a site that is defined as a site susceptible to groundwater contamination under s. NR 151.015 (18). NR 151.055(3)(g)(g) Other factors relevant to the impact of the discharge on water quality standards of the receiving water or to groundwater standards. NR 151.055 NoteNote: Existing technical standards contained in the U.S. department of agriculture natural resources conservation service field office technical guide may be used for managing process wastewater. When such standards are not applicable, the landowner or operator is expected to take reasonable steps to reduce the significance of the discharge in accordance with the agricultural performance standard and prohibition compliance requirements of this chapter. The Wisconsin department of agriculture, trade and consumer protection is responsible under s. 281.16 (3) (c), Stats., for developing additional management practices if needed. NR 151.055 HistoryHistory: CR 09-112: cr. Register December 2010 No. 660, eff. 1-1-11. NR 151.06NR 151.06 Clean water diversion performance standard. NR 151.06(1)(1) All livestock producers within a water quality management area shall comply with this section. NR 151.06(2)(2) Runoff shall be diverted away from contacting feedlot, manure storage areas and barnyard areas within water quality management areas except that a diversion to protect a private well under s. NR 151.015 (18) (a) is required only when the feedlot, manure storage area or barnyard area is located upslope from the private well. NR 151.07(1)(1) All crop producers and livestock producers that apply manure or other nutrients directly or through contract to agricultural fields shall comply with this section. NR 151.07 NoteNote: Manure management requirements for concentrated animal feeding operations covered under a WPDES permit are contained in ch. NR 243. NR 151.07(2)(2) This performance standard does not apply to the application of industrial waste and byproducts regulated under ch. NR 214, municipal sludge regulated under ch. NR 204, and septage regulated under ch. NR 113, provided the material is not commingled with manure prior to application. NR 151.07 NoteNote: In accordance with ss. ATCP 50.04, 50.48 and 50.50, nutrient management planners, Wisconsin certified soil testing laboratories and dealers of commercial fertilizer are advised to make nutrient management recommendations based on the performance standard for nutrient management, s. NR 151.07, to ensure that their customers comply with this performance standard. NR 151.07 NoteNote: If an application of material to cropland is regulated under ch. NR 113, 204, or 214, the management practices, loading limitations, and other restrictions specified in the applicable regulation apply to that application. However, nutrient management plans developed in accordance with this performance standard must account for all nutrient sources, including industrial waste and byproducts, municipal sludge, and septage. This means that the future application of manure and commercial fertilizer may be restricted by this performance standard due to other applications of industrial waste and byproducts, municipal sludge, and septage. In addition, it means that if industrial waste and byproducts, municipal sludge, or septage are placed in a manure storage structure and mixed with manure, the commingled material is also covered by this standard and must be accounted for by the producer when preparing and implementing a nutrient management plan. NR 151.07(3)(3) Manure, commercial fertilizer and other nutrients shall be applied in conformance with a nutrient management plan. NR 151.07(3)(a)(a) The nutrient management plan shall be designed to limit or reduce the discharge of nutrients to waters of the state for the purpose of complying with state water quality standards and groundwater standards. NR 151.07(3)(b)(b) Nutrient management plans for croplands in watersheds that contain impaired surface waters or in watersheds that contain outstanding or exceptional resource waters shall meet the following criteria: NR 151.07(3)(b)1.1. Unless otherwise provided in this paragraph, the plan shall be designed to manage soil nutrient concentrations so as to maintain or reduce delivery of nutrients contributing to the impairment of impaired surface waters and to outstanding or exceptional resource waters. NR 151.07(3)(b)2.2. The plan may allow for an increase in soil nutrient concentrations at a site if necessary to meet crop demands. NR 151.07(3)(b)3.3. For lands in watersheds containing exceptional or outstanding resource waters, the plan may allow an increase in soil nutrient concentrations if the plan documents that any potential nutrient delivery to the exceptional or outstanding resource waters will not alter the background water quality of the exceptional or outstanding resource waters. For lands in watersheds containing impaired waters, the plan may allow an increase in soil nutrient concentrations if a low risk of delivery of nutrients from the land to the impaired water can be demonstrated. NR 151.07(3)(c)(c) In this standard, impaired surface waters are waters identified as impaired pursuant to 33 USC 1313 (d) (1) (A) and 40 CFR 130.7. Outstanding or exceptional resource waters are identified in ch. NR 102. NR 151.07(4)(4) This section is in effect on January 1, 2005 for existing croplands under s. NR 151.09 (4) that are located within any of the following: NR 151.07(4)(a)(a) Watersheds containing outstanding or exceptional resource waters. NR 151.07 NoteNote: The purpose of the phased implementation of this standard is to allow the department sufficient time to work with the Department of Agriculture, Trade and Consumer Protection and local governmental units to develop and implement an information, education and training program on nutrient management for affected stakeholders.
NR 151.075NR 151.075 Silurian bedrock performance standards. NR 151.075(1)(1) All crop producers and livestock producers that mechanically apply manure directly or through contract or other agreement to cropland or pasture areas that meet the definition of Silurian bedrock under s. NR 151.015 (17) must comply with this section. NR 151.075(2)(2) Mechanical manure application may not cause the fecal contamination of water in a well. NR 151.075(3)(3) Manure may not be mechanically applied on areas of cropland or pastures that have 24 inches or less of separation between the ground surface and apparent water table. NR 151.075(4)(4) Manure must be applied in conformance with a nutrient management plan that meets the requirements under all the following: NR 151.075(4)(b)(b) The plan must be consistent with NRCS Technical Standard 590, dated December 2015. NR 151.075(4)(c)(c) The plan must be designed and implemented consistent with this section to manage manure so as to reduce the risk of pathogen delivery to groundwater and prevent exceedances of groundwater water quality standards. NR 151.075(4)(d)(d) The plan must use NRCS soil survey maps/information or other methods as a planning tool to identify Silurian bedrock within or adjacent to cropland and pastures. NR 151.075(5)(5) Manure may not be mechanically applied on croplands or pastures until infield bedrock verification or Silurian bedrock map information is used to identify areas where the Silurian bedrock soil depth is less than 5 feet. If infield bedrock verification uses drill cores or other subsurface investigations, they must be backfilled with soil within 72 hours of being created. NR 151.075 NoteNote: Silurian bedrock map information developed by the department of agriculture, trade and consumer protection and/or department of natural resources, may be used alone or in combination to meet the requirements of this section.
NR 151.075 NoteNote: Silurian bedrock map information, available from the University of Wisconsin department of soil science, can be found at https://snapplus.wisc.edu/maps/ . NR 151.075(6)(6) Manure may not be mechanically applied on croplands or pastures where the Silurian bedrock soil depth is less than 5 feet until such fields are evaluated and ranked for risk of pathogen delivery to groundwater. Areas determined to have a high risk for pathogen delivery to groundwater must be avoided or must be lowest priority for manure application. NR 151.075(7)(7) Mechanical application of manure and headland stacking of manure is prohibited on soils with 5 feet or less to Silurian bedrock when soils are frozen or snow covered. NR 151.075(8)(8) Mechanical application of manure is prohibited within Silurian bedrock having soil depths less than 5 feet when rainfall greater than one inch is forecast within 24 hours of planned application. NR 151.075(9)(9) Mechanical application of manure is prohibited for soils with less than 2 feet to Silurian bedrock. NR 151.075(10)(10) For soils with 2 to 3 feet to Silurian bedrock, all the following apply: NR 151.075(10)(a)(a) No mechanical application of solid manure unless all the following are met: NR 151.075(10)(a)1.1. Solid manure is incorporated within 72 hours to no more than 4 inches below ground. NR 151.075(10)(a)2.a.a. Solid manure is applied at a rate no greater than 15 tons/acre/year, or the rate that supplies the crop nitrogen recommendation from UW A2809, whichever is less. NR 151.075(10)(a)2.b.b. Solid manure is applied in compliance with UW A2809 and within 10 days of the planting date or applied on a perennial or established crop. NR 151.075(10)(a)2.c.c. Solid manure is composted or treated to reduce pathogen levels via practices to a fecal coliform bacteria density of less than 500,000 colony-forming units or most probable number per gram total solids on a dry weight basis. NR 151.075 NoteNote: Copies of the University of Wisconsin — Extension publication A2809 Nutrient Application Guidelines for Field, Vegetable, and Fruit Crops in Wisconsin, dated 2012 (A2809) may be inspected at the office of the department, the Wisconsin Department of Agriculture, Trade and Consumer Protection and the legislative reference bureau, Madison, Wisconsin. A2809 is also available electronically at: http://learningstore.uwex.edu/assets/pdfs/A2809.pdf. NR 151.075(10)(b)(b) No mechanical application of liquid manure unless all the following are met: NR 151.075(10)(b)2.2. Liquid manure is injected or incorporated within 24 hours to no more than 4 inches below ground, unless exempt under par. (c). NR 151.075(10)(b)3.a.a. Total liquid manure application is applied in compliance with UW A2809, or limited to Table 1, whichever is less, to prevent hydraulic overloading of the soil. NR 151.075(10)(b)3.b.b. Liquid manure is applied in compliance with UW A2809 and within 10 days of the planting date or applied on a perennial or established crop. NR 151.075(10)(b)3.c.c. Liquid manure is treated to substantially reduce pathogen levels via practices to a fecal coliform bacteria density of less than 500,000 most probable number or colony-forming units per 100 milliliter sample. NR 151.075 NoteNote: Copies of the University of Wisconsin — Extension publication A2809 Nutrient Application Guidelines for Field, Vegetable, and Fruit Crops in Wisconsin, dated 2012 (A2809) may be inspected at the office of the department, the Wisconsin Department of Agriculture, Trade and Consumer Protection and the legislative reference bureau, Madison, Wisconsin. A2809 is also available electronically at: http://learningstore.uwex.edu/assets/pdfs/A2809.pdf. NR 151.075(10)(c)(c) Pre-tillage, incorporation or injection is not required if cropland or pastures meet long term no-till or have a perennial or established crop. Each surface application of liquid manure must not exceed 6,750 gallons per acre. NR 151.075(10)(d)(d) Pre-tillage is not required if demonstrated to the department that a field cannot meet s. NR 151.02 over an eight-year crop rotation using a combination of the following practices: tillage, crops, contouring, filter strips, or cover crops. NR 151.075(11)(11) For soils with 3 to 5 feet to Silurian bedrock, all the following apply: NR 151.075(11)(a)(a) No mechanical application of solid manure unless all the following are met: NR 151.075(11)(a)2.a.a. Manure is applied in accordance with UW A2809 annual application rate, or at a rate of 15 tons/acre/year, whichever is less. NR 151.075(11)(a)2.b.b. Manure is applied in compliance with UW A2809 and within 10 days of the planting date or applied on a perennial or established crop. NR 151.075(11)(a)2.c.c. Manure is composted or treated to reduce pathogen levels via practices to a fecal coliform bacteria density of 500,000 colony-forming units, or most probable number per gram total solids on a dry weight basis. NR 151.075 NoteNote: Copies of the University of Wisconsin — Extension publication A2809 Nutrient Application Guidelines for Field, Vegetable, and Fruit Crops in Wisconsin, dated 2012 (A2809) may be inspected at the office of the department, the Wisconsin Department of Agriculture, Trade and Consumer Protection and the legislative reference bureau, Madison, Wisconsin. A2809 is also available electronically at: http://learningstore.uwex.edu/assets/pdfs/A2809.pdf NR 151.075(11)(b)(b) No mechanical application of liquid manure unless all the following are met: NR 151.075(11)(b)2.2. Liquid manure is injected or incorporated within 24 hours to no more than 6 inches below ground, unless exempt under par. (c). NR 151.075(11)(b)3.a.a. Total liquid manure application is applied in compliance with UW A2809, or limited to sub. (10) (b) 3. Table 1 rates, whichever is less, to prevent hydraulic overloading of the soil. NR 151.075(11)(b)3.b.b. Liquid manure is applied in compliance with UW A2809 and within 10 days of the planting date or applied on a perennial or established crop.
/code/admin_code/nr/100/151
true
administrativecode
/code/admin_code/nr/100/151/ii/07/3/c
Department of Natural Resources (NR)
Chs. NR 100-199; Environmental Protection – General
administrativecode/NR 151.07(3)(c)
administrativecode/NR 151.07(3)(c)
section
true
