SB225,,55 (7) A manufacturer shall provide its dealer with adequate technical data to perform proper service and repairs.

SB225,20 Section 20. 218.162 of the statutes is created to read:

SB225,,57 218.162 Termination of dealer agreement. (1) (a) A manufacturer or distributor, directly or through any officer, agent, or employee, may terminate, cancel, or fail to renew a model, line-make, or entire dealer agreement only with good cause, and, upon renewal, may not require additional inventory stocking requirements or increased retail sales targets in excess of the market growth in the dealer’s area of sales responsibility.

SB225,,58 (b) A manufacturer or distributor has the burden of showing good cause for terminating, canceling, or failing to renew a model, line-make, or dealer agreement with a dealer. For purposes of determining whether there is good cause for the proposed action, any of the following factors may be considered:

SB225,,59 1. The extent of the affected dealer’s penetration in the relevant market area for the relevant model or line-make.

SB225,,60 2. The nature and extent of the dealer’s investment in its business.

SB225,,61 3. The adequacy of the dealer’s service facilities, equipment, parts, supplies, and personnel.

SB225,,62 4. The effect of the proposed action on the community.

SB225,,63 5. The extent and quality of the dealer’s service under recreational vehicle warranties.

SB225,,64 6. The failure to follow agreed-upon, reasonable procedures or standards related to the overall operation of the dealership consistent with the law and the dealer agreement.

SB225,,65 7. The dealer’s performance under the terms of its dealer agreement.

SB225,,66 (c) 1. Except as provided in this paragraph, a manufacturer or distributor shall provide a dealer with at least 120 days’ prior written notice of termination, cancellation, or nonrenewal of a model, line-make, or entire dealer agreement.

SB225,,67 2. The notice under subd. 1. shall state all reasons for the proposed termination, cancellation, or nonrenewal and shall state that if, within 30 days following receipt of the notice, the dealer provides to the manufacturer or distributor a written notice of intent to cure all claimed deficiencies, the dealer will then have 120 days following receipt of the notice to rectify the deficiencies. If the deficiencies are rectified within 120 days, the manufacturer’s or distributor’s notice is voided. If the dealer fails to provide the notice of intent to cure the deficiencies in the prescribed period, the termination, cancellation, or nonrenewal takes effect 30 days after the dealer’s receipt of the notice unless the dealer has new and untitled inventory on hand that may be disposed of as provided under sub. (3).

SB225,,68 3. The notice period under subd. 1. may be reduced to 30 days if the grounds for termination, cancellation, or nonrenewal are due to any of the following:

SB225,,69 a. A dealer or one of its owners being convicted of a felony.

SB225,,70 b. The abandonment or closing of the business operations of the dealer for 10 consecutive business days unless the closing is due to an act of God, strike, labor difficulty, or other cause over which the dealer has no control.

SB225,,71 c. A significant misrepresentation by the dealer materially affecting the business relationship.

SB225,,72 d. A suspension of, revocation of, or refusal to renew the dealer’s license by the department.

SB225,,73 4. The notice provisions of this paragraph do not apply if the reason for termination, cancellation, or nonrenewal is insolvency, the occurrence of an assignment for the benefit of creditors, or bankruptcy.

SB225,,74 (2) A dealer may terminate, cancel, or fail to renew a model, line-make, or entire dealer agreement with a manufacturer or distributor with or without good cause at any time by giving 30 days’ written notice to the manufacturer. If the termination, cancellation, or nonrenewal is for good cause, the dealer has the burden of showing good cause. Any of the following items, among others, may be deemed good cause for the proposed action by a dealer:

SB225,,75 (a) A manufacturer being convicted of a felony.

SB225,,76 (b) The business operations of the manufacturer have been abandoned or closed for 10 consecutive business days, unless the closing is due to an act of God, strike, labor difficulty, or other cause over which the manufacturer has no control.

SB225,,77 (c) A significant misrepresentation by the manufacturer materially affecting the business relationship.

SB225,,78 (d) A material violation of this subchapter that is not cured within 30 days after written notice by the dealer.

SB225,,79 (e) A declaration by the manufacturer of insolvency, the occurrence of an assignment for the benefit of creditors, or bankruptcy.

SB225,,80 (f) A manufacturer’s material violation of the dealer agreement that is not cured within 120 days after written notice by the dealer.

SB225,,81 (g) Manufacturer coercion of the dealer under s. 218.166.

SB225,,82 (h) Manufacturer violation of area of sales responsibility protections or allowing other dealers to violate these protections.

SB225,,83 (3) If the dealer agreement is terminated, canceled, or not renewed by the dealer for good cause, the manufacturer shall, at the election of the dealer and within 45 days after termination, cancellation, or nonrenewal, repurchase all of the following: