NR 445.08(7)(b)(b) For all sources, submit all of the following information to the department: NR 445.08(7)(b)1.1. The hazardous air contaminants in Table A, B and C of s. NR 445.07 the facility is capable of emitting in an amount greater than the threshold value listed for the contaminant in the applicable table. NR 445.08(7)(b)2.2. The emission limitation applicable to each hazardous air contaminant identified under subd. 1. NR 445.08(7)(b)3.3. The method or combination of methods used for achieving compliance under sub. (2) or (3) with the applicable standard for each hazardous air contaminant. NR 445.08(7)(b)4.4. A description of the records that will be kept on site to verify continuous compliance for each hazardous air contaminant with its applicable standard. NR 445.08(7)(b)5.5. A signed and dated statement by the responsible official stating that the information is accurate to the best of his or her knowledge and belief, and that all of the requirements of this subchapter have been met. NR 445.08 NoteNote: Application forms for par. (a) may be obtained from, and submitted to, the regional offices and service centers of the department or:
Wisconsin Department of Natural Resources
Bureau of Air Management
PO Box 7921
Madison WI 53707-7921
Attention: Operation Permits.
The address for submittal of information under par. (b) is:
Wisconsin Department of Natural Resources
Bureau of Air Management
PO Box 7921
Madison WI 53707-7921
Attention: NR 445 Compliance Notifications.
NR 445.08(8)(8) Department review. The department shall review information submitted to comply with sub. (6) (c) 1. to determine whether to approve, conditionally approve or disapprove the source’s method to meet applicable control requirements. NR 445.08(9)(9) Extensions to compliance schedule. The department may, at the request of the owner or operator of a source, grant an extension of any applicable compliance deadline in sub. (6) (b) or (c) 1. or 2. or s. NR 445.09 (4) (a) or (b) for a period not to exceed 180 calendar days. NR 445.08(10)(a)(a) Notwithstanding the compliance deadline in sub. (6) (c) 2., a source needing department approval under sub. (8) shall achieve final compliance with applicable control requirements by the later of: NR 445.08(10)(b)(b) The owner or operator of a source that achieved compliance with requirements of this chapter by installing emission control equipment prior to July 1, 2004 may not be required to install additional control equipment to achieve compliance with this chapter for a period of 10 years after the installation of the control equipment or the useful life of the control equipment as determined by the department, whichever is less. For the purposes of this paragraph, increasing stack height, other dilution measures or material reformulation may not be construed as installation of emission control equipment. Material reformulation that requires substantial capital expenditures for process equipment that was carried out with prior department approval and that results in a reduction of emissions of hazardous air contaminants that is sufficient to comply with the limitations of this chapter may be construed as installation of emission control equipment under this paragraph. NR 445.08 HistoryHistory: CR 02-097: cr. Register June 2004 No. 582, eff. 7-1-04; CR 07-076: am. (6) (d) 1., 2. (intro.), a. and (10) (b) Register July 2008 No. 631, eff. 8-1-08; 2011 Wis. Act 122: r. (3) (c), (6) (d) 1., 2. (intro.) (in part) a., b.; s. 35.17 correction in (6) (c) 2. made under s. 35.17, Stats., Register March 2016 No. 723. NR 445.09NR 445.09 Fuel, control and compliance requirements for compression ignition internal combustion engines combusting fuel oil. NR 445.09(1)(1) Applicability. This section applies to any compression ignition internal combustion engine that is capable of combusting fuel oil, except for any of the following: NR 445.09(1)(a)(a) An engine with rated brake power less than 100 horsepower. NR 445.09(1)(d)(d) An engine manufactured after July 1, 2004 installed to provide substitute power during maintenance or repair of a CI engine subject to sub. (3) (a), provided the substitute engine has a power rating equal to or less than the existing engine, operates less than 10 consecutive days per substitution and meets the fuel requirement in sub. (2). NR 445.09(1)(e)(e) An engine that meets the fuel requirement in sub. (2) and is approved by US EPA to meet either of the following: NR 445.09(1)(e)1.1. The Tier 2 particulate emission standard for nonroad engines as found in 40 CFR part 89 for an engine that meets either of the following: NR 445.09(1)(e)1.a.a. Is purchased prior to January 1, 2011 and rated at 175 horsepower or greater. NR 445.09(1)(e)1.b.b. Is purchased prior to January 1, 2012 and rated from 100 to less than 175 horsepower.