This is the preview version of the Wisconsin State Legislature site.
Please see http://docs.legis.wisconsin.gov for the production version.
NR 283.11(2) (2) The department shall obtain the average process water usage flow rate for the contact cooling and heating water processes from the permittee.
NR 283.11 History History: Cr. Register, October, 1987, No. 382, eff. 11-1-87.
NR 283.12 NR 283.12Effluent limitations representing the degree of effluent reduction attainable by the application of the best available technology economically achievable. Based on EPA's determination that BPT provides adequate control of toxic pollutants in contact cooling and heating process wastewater, BAT guidelines are equivalent to BPT guidelines.
NR 283.12 Note Note: BAT effluent limitations for bis(2-ethylhexyl) phthalate are reserved.
NR 283.12 History History: Cr. Register, October, 1987, No. 382, eff. 11-1-87.
NR 283.13 NR 283.13New source performance standards.
NR 283.13(1)(1) Any new source subject to this subchapter shall achieve performance standards which are calculated by multiplying the average process water usage flow rate for the contact cooling and heating water processes at a new source times the pollutant concentrations indicated in Table 1.
NR 283.13(2) (2) The department shall obtain the average process water usage flow rate for the new source contact cooling and heating water processes from the permittee.
NR 283.13 Note Note: NSPS for bis(2-ethylhexyl) phthalate are reserved.
NR 283.13 History History: Cr. Register, October, 1987, No. 382, eff. 11-1-87.
NR 283.14 NR 283.14Pretreatment standards for existing sources. Any existing source subject to this subchapter that introduces pollutants into a POTW shall comply with ch. NR 211.
NR 283.14 Note Note: PSES for bis(2-ethylhexyl) phthalate are reserved.
NR 283.14 History History: Cr. Register, October, 1987, No. 382, eff. 11-1-87.
NR 283.15 NR 283.15Pretreatment standards for new sources. Any new source subject to this subchapter that introduces pollutants into a POTW shall comply with ch. NR 211.
NR 283.15 Note Note: PSNS for bis(2-ethylhexyl) phthalate are reserved.
NR 283.15 History History: Cr. Register, October, 1987, No. 382, eff. 11-1-87.
NR 283.16 NR 283.16Effluent limitations representing the degree of effluent reduction attainable by the application of the best conventional pollutant control technology.
NR 283.16(1)(1) Except as provided in 40 CFR 125.30 to 125.32, any existing point source subject to this subchapter shall achieve the effluent limitations representing the degree of effluent reduction attainable by the application of BCT which are calculated by multiplying the average process water usage flow rate for the contact cooling and heating water processes at a point source times the pollutant concentrations indicated in Table 1.
NR 283.16(2) (2) The department shall obtain the average process water usage flow rate for the contact cooling and heating water processes from the permittee.
NR 283.16 History History: Cr. Register, October, 1987, No. 382, eff. 11-1-87.
subch. III of ch. NR 283 Subchapter III - Cleaning Water Subcategory
NR 283.20 NR 283.20Applicability; description of the cleaning water subcategory. This subchapter applies to the discharge of pollutants from processes in the cleaning water subcategory to waters of the state and the introduction of pollutants into POTWs. The cleaning water subcategory is limited to processes where process water contacts the surface of an intermediate or final plastic product, or the surfaces of shaping equipment used in plastics molding and forming, for the purpose of surface cleaning.
NR 283.20 History History: Cr. Register, October, 1987, No. 382, eff. 11-1-87.
NR 283.21 NR 283.21Effluent limitations representing the degree of effluent reduction attainable by the application of the best practicable control technology currently available.
NR 283.21(1)(1) Except as provided in 40 CFR 125.30 to 125.32, any existing point source subject to this subchapter shall achieve the effluent limitations representing the degree of effluent reduction attainable by the application of BPT, which is calculated by multiplying the average process water usage flow rate for the cleaning water processes at a point source times the following pollutant concentrations: - See PDF for table PDF
NR 283.21(2) (2) The department shall obtain the average process water usage flow rate for the cleaning water processes from the permittee.
NR 283.21 History History: Cr. Register, October, 1987, No. 382, eff. 11-1-87.
NR 283.22 NR 283.22Effluent limitations representing the degree of effluent reduction attainable by the application of the best available technology economically achievable. Based on EPA's determination that BPT provides adequate control of toxic pollutants in cleaning process wastewater, BAT guidelines are equivalent to BPT guidelines.
NR 283.22 History History: Cr. Register, October, 1987, No. 382, eff. 11-1-87.
NR 283.23 NR 283.23New source performance standards.
NR 283.23(1)(1) Any new source subject to this subchapter shall achieve performance standards calculated by multiplying the average process water usage flow rate for cleaning processes at a new source times the pollutant concentrations indicated in Table 2.
NR 283.23(2) (2) The department shall obtain the average process water usage flow rate for the new source cleaning water processes from the permittee.
NR 283.23 History History: Cr. Register, October, 1987, No. 382, eff. 11-1-87.
NR 283.24 NR 283.24Pretreatment standards for existing sources. Any existing source subject to this subchapter that introduces pollutants into a POTW shall comply with ch. NR 211.
NR 283.24 History History: Cr. Register, October, 1987, No. 382, eff. 11-1-87.
NR 283.25 NR 283.25Pretreatment standards for new sources. Any new source subject to this subchapter that introduces pollutants into a POTW shall comply with ch. NR 211.
NR 283.25 History History: Cr. Register, October, 1987, No. 382, eff. 11-1-87.
subch. IV of ch. NR 283 Subchapter IV - Finishing Water Subcategory
NR 283.30 NR 283.30Applicability; description of the finishing water subcategory. This subchapter applies to the discharge of pollutants from processes in the finishing water subcategory to waters of the state and the introduction of pollutants into POTWs. The finishing water subcategory is limited to processes where process water contacts the plastic product for the purpose of removing waste plastic material or lubricating a plastic product during finishing.
NR 283.30 History History: Cr. Register, October, 1987, No. 382, eff. 11-1-87.
NR 283.31 NR 283.31Effluent limitations representing the degree of effluent reduction attainable by the application of the best practicable control technology currently available.
NR 283.31(1)(1) Except as provided in 40 CFR 125.30 to 125.32, any existing point source subject to this subchapter shall achieve the effluent limitations representing the degree of effluent reduction attainable by the application of BPT, which is calculated by multiplying the average process water usage flow rate for the finishing water processes at a point source times the following pollutant concentrations: - See PDF for table PDF
NR 283.31(2) (2) The department shall obtain the average process water usage flow rate for the finishing water processes from the permittee.
NR 283.31 History History: Cr. Register, October, 1987, No. 382, eff. 11-1-87.
NR 283.32 NR 283.32Effluent limitations representing the degree of effluent reduction attainable by the application of the best available technology economically achievable. Based on EPA's determination that BPT provides adequate control of toxic pollutants in finishing process wastewater, BAT guidelines are equivalent to BPT guidelines.
NR 283.32 Note Note: BAT effluent limitations for bis(2-ethylhexyl) phthalate, di-n-butyl phthalate, and dimethyl phthalate are reserved.
NR 283.32 History History: Cr. Register, October, 1987, No. 382, eff. 11-1-87.
NR 283.33 NR 283.33New source performance standards.
NR 283.33(1)(1) Any new source subject to this subchapter shall achieve performance standards which are calculated by multiplying the average process water usage flow rate for the finishing water processes at a new source times the pollutant concentrations indicated in Table 3.
NR 283.33(2) (2) The department shall obtain the average process water usage flow rate for the new source finishing water processes from the permittee.
NR 283.33 Note Note: NSPS for bis(2-ethylhexyl) phthalate, di-n-butyl phthalate, and dimethyl phthalate are reserved.
NR 283.33 History History: Cr. Register, October, 1987, No. 382, eff. 11-1-87.
NR 283.34 NR 283.34Pretreatment standards for existing sources. Any existing source subject to this subchapter that introduces pollutants into a POTW shall comply with ch. NR 211.
NR 283.34 Note Note: PSES for bis(2-ethylhexyl) phthalate, di-n-butyl phthalate, and dimethyl phthalate are reserved.
NR 283.34 History History: Cr. Register, October, 1987, No. 382, eff. 11-1-87.
NR 283.35 NR 283.35Pretreatment standards for new sources. Any new source subject to this subchapter that introduces pollutants into a POTW shall comply with ch. NR 211.
NR 283.35 Note Note: PSNS for bis(2-ethylhexyl) phthalate, di-n-butyl phthalate, and dimethyl phthalate are reserved.
NR 283.35 History History: Cr. Register, October, 1987, No. 382, eff. 11-1-87.
NR 283.40 NR 283.40Cross-references. The federal citations in this chapter correspond to provisions of the Wisconsin administrative code and Wisconsin statutes. The federal citations may be cross-referenced in the following table: - See PDF for table PDF
NR 283.40 History History: Cr. Register, October, 1987, No. 382, eff. 11-1-87.
Loading...
Loading...
Published under s. 35.93, Stats. Updated on the first day of each month. Entire code is always current. The Register date on each page is the date the chapter was last published.